DAB GENIX, Инструкция по установке и обслуживанию

Страница: 12 / 25

ENGLISH
GB
Digits in the following sections refer to the pictures in the appendix “ Trou-
bleshooting ”.
Before carrying out any service work, remove the fuse, pull out
the plug, or switch off the power supply. Make sure that the power
supply cannot be accidentally switched on.All rotating parts must
have stopped moving.The product must only be serviced by trai -
ned service personnel.
Impeller/grinder stuck
1. Disconnect the power supply
2. Remove the motor cover cap.
3. Insert a screwdriver (min. 110 mm) through the plug hole and into the
slot of the shaft end.Turn the shaft right and left to free the impeller/grinder
from dirt.
Operation by means of a power drill
1. Disconnect the power supply
2. If the product cannot be operated by electrical power, the toilet and
system can be emptied by means of a power drill.
Pressure switch pipe clogged
1. Disconnect the power supply
2. Unscrew the screw of the motor cover and remove the cover
3. If the water level is above the motor flange, empty the tank by means of
the appropriate tap and the hose (supplied).
4. Unscrew the screws of the board holder.
5. Remove the pressure switch pipe.
6. Clean the rubber hose and check the opening on the tank
Foreign body in tank
1. Disconnect the power supply
2. Unscrew the screw of the motor cover and remove the cover
3. If the water level is above the motor flange, empty the tank by means of
the appropriate tap and the hose (supplied).
4. Unscrew the side screw of the motor ring
5. Lift the motor flange to reduce the compression of the O-ring. Insert a
screwdriver into the notch underneath the supply cable and press it down.
6. Extract the complete motor unit by means of the handles (lift the unit
vertically before tilting it).
7. Check and clean the tank and impeller/grinder.
Beware of the sharp edges on the grinder.
Wear protective gloves.
Carbon filter
1. Remove the filter cover
2. Replace the filter
The carbon filter should be replaced once a year to ensure sufficient
filter function.
Instead of using the activated carbon filter, the system can also vent
through a vent pipe with diameter 20.
7. TECHNICAL DATA
Model Hz
Volt
(V) P1 (W)
Amp
(A) Cos ᵠ
Hmax
pump
(m)
Flow
max
(m3/h)
Genix
50
220-
240
490 2.3
0.95
0.91
8.0 6.9
60 115
60 127
Genix
Comfort
50
220-
240
490 2.3
0.95
0.91
8.0 6.9
60 115
60 127
• Supply voltage: see electrical data plate
• Maximum operating pressure: 90 kPa / 0.9 bar / 13 psi
• Grade of motor protection: IP44
• Protection rating: F
• Noise level:
<70dB(A) to 12050-3
12