DAB EVOPLUS SMALL 60/180 M, Инструкция по установке и обслуживанию, Страница: 17 / 260

ENGLISH
GB
15
1.
KEY
The frontispiece shows the version of this document in the form Vn.x.
This version indicates that the document is valid for all software ver-
sions of the device n.y. For example: V3.0 is valid for all Sw: 3.y
In this document the following symbols will be used to avoid situations
of ranger:
Situation of general danger . Failure to respect the instruc-
tions that follow may cause harm to persons and property.
Situation of electric shock hazard . Failure to respect the instruc-
tions that follow may cause a situation of grave risk for personal
safety.
2. GENERAL
Read this documentation carefully before installation.
Installation, electrical connection and commissioning must be carried out
by specialised personnel, in compliance with the general and local safety
regulations in force in the country in which the product is installed. Failure
to respect these instructions not only causes risk to personal safety and
damage to the equipment, but invalidates every right to assistance under
guarantee.
The appliance is not intended to be used by persons (including children)
with reduced physical, sensory or mental capacities, or who lack experi-
ence or knowledge, unless, through the mediation of a person responsi-
ble for their safety, they have had the benefit of supervision or of instruc
-
tions on the use of the appliance. Children must be supervised to ensure
that they do not play with the appliance.
Ensure that the product has not suffered any damage during
transport or storage. Check that the outer casing is unbroken
and in excellent conditions.
2.1 Safety
Use is allowed only if the electric system is in possession of safety pre-
cautions in accordance with the regulations in force in the country where
the product is installed.
2.2 Responsibility
The Manufacturer does not vouch for correct operation of the machine or
answer for any damage that it may cause if it has been tampered with,
modified and/or run outside the recommended work range or in contrast
with other indications given in this manual.
2.3 Particular warnings
Always switch off the mains power supply before working on the
electrical or mechanical part of the system. Wait for the warning
lights on the control panel to go out before opening the appli-
ance. The capacitor of the direct current intermediate circuit
remains charged with dangerously high voltage even after the
mains power has been turned off.
Only firmly cabled mains connections are admissible. The appli
-
ance must be earthed (IEC 536 class 1, NEC and other applicable
standards).
Mains terminals and motor terminals may still have dangerous
voltage when the motor is stopped.
If the power cable is damaged, it must be replaced by the techni-
cal assistance service or by qualified personnel, so as to avoid
any risk.