SCREEN ADJUSTMENT
Surface travel is stopped automatically in the fully opened and closed positions by limit switches that are properly
adjusted at Da-Lite. Should it be necessary to adjust more or less drop of picture, proceed in the following manner:
CAUTION! WHEN ADJUSTING AND TESTING, BE PREPARED TO STOP SCREEN QUICKLY AS SERIOUS DAMAGE MAY OCCUR.
NOTE:
Use a screw driver or allen wrench to make adjustments.
MORE SCREEN DROP
1. Place operating switch in
“down”
position.
2. When the screen stops, turn the white
“down”
limit knob (Fig. 3) one-quarter turn counterclockwise. Test by raising
picture surface approximately two feet, then lower again. Repeat until desired picture surface position is attained.
NOTE:
Must leave at least 1-1/2 wraps of fabric on roller.
LESS SCREEN DROP
1. Raise picture surface approximately two feet above desired level.
2. Place operating switch in
“off”
position.
3. Turn the white
“down”
limit switch (Fig. 3) one-quarter turn clockwise. Test by raising picture surface approximately
two feet, then lower again. Repeat until desired picture surface position is attained.
2
WHITE ADJUSTMENT
KNOB “DOWN”
s
!
YELLOW OR RED
ADJUSTMENT
KNOB “UP”
SLAT
FIGURE 3
SHIPPING BRACE
(NOT ON 4-1/2" ROLLER)
Содержание TENSIONED PROFESSIONAL ELECTROL
Страница 7: ...6 ...
