Da-Lite Curved Multi Format Imager, Инструкция

Страница: 8 / 16

8
Figure 12
Curved Multi Format Imager Installation – Wall Mount
1. The screen is shipped with one wall hanger board. Two small
brackets are included to hold the frame securely to wall
at the bottom.
2. The wall hanger board must be mounted into at least four
wall studs; it must be horizontally leveled.
3. Secure wall hanger board to wall studs at the desire height.
Drill holes and attach wall hanger board into wall. You
will need about 3” clearance above the top surface of the
board. It is recommended to use a 1/4” x 2-1/2” lag screw and
1/4" flat washer (not supplied) to fasten the board to wall.
NOTE: the top surface of the wall hanger board will align the
top surface of the screen.
4. This step must be done by a lifting device or enough people
to safely lift the weight of the screen over the wall hanger
board. Lift the screen about 3” over the wall hanger board.
5. Align the wood guide of the board with the metal guide of
the screen. Make sure the sides of the screen are located at
the same distance from the wall.
6. Move the screen until slightly touches the wall and let it come
down slowly until it rests on the metal brackets. There is a lip
on the back of the frame that slides down on the surfaces of
the two metal brackets.
7. Attach two small brackets to the bottom of the frame with
two #10 x 3/8” button head screws. Secure brackets to wall
with two screws (not supplied).
8. Attach two side covers with (6) #10 x 3/8” button head screws.
Metal Bracket
(8) 1/4" x 2 1/2" Lag Screws And
(8) 1/4" Flat Washers on
(4) Wall Studs Minimum
(Lag Screws And Flat
Washers Not Supplied)
Side Cover
Side Cover
Metal Bracket
Black Screw
Small Bottom
Bracket
Metal Guide
Wood Guide
Wall Hanger Board