![background image](http://html1.mh-extra.com/html/da-lite/cinema-contour-screen/cinema-contour-screen_instruction-book_3139259003.webp)
2
2. To install the lower wall bracket, you must measure
the overall height of the screen frame and subtract
1-3/8". Using that dimension, measure down from the
top edge of the wall bracket and mark the wall for
two screw holes. The holes should be centered
within the frame and 6" apart. Refer to Figure 3.
3. Attach the small wall bracket to the wall. Refer to
Figure 4 for proper orientation. Do not tighten the
screws completely. The bracket should slide up and
down easily.
4. Unroll the screen on a clean surface. Do not use
newspaper. The viewing side is rolled to the inside of
the roll. Place the frame over the screen surface, and
while lifting the frame with one hand, snap the
screen surface onto the frame with the other hand
while maintaining a steady pull on the surface.
5. Hang the screen on the brackets by hooking the
bottom of the frame onto the lower wall bracket and
lift up until you can hook the top of the frame on the
top bracket. Push down on the frame to seat it on the
brackets. Refer to Figure 4.
METHOD 1 (SCREENS 80" AND SMALLER IN
VIEWING WIDTH)
There are four methods of installation based on the size
of the screen and type of viewing surface. Measure the
width of the viewing area of your screen and refer to the
appropriate method of installation below. The wall
bracket diagram shows the type and quantity of
bracket(s) supplied based on the size of the screen.
Method 1: Screens 80" and smaller in viewing width.
Method 2: Screens over 80" up to 96" in viewing width.
Method 3: Screens over 96" in viewing width.
Method 4: Any size screen with High Power
®
viewing
surface.
INSTALLATION
FIGURE 2
SMALL WALL BRACKET
1-PIECE
FIGURE 3
FIGURE 4
LARGE WALL
BRACKET
1-PIECE
LARGE WALL BRACKET
OVERALL HEIGHT LESS 1-3/8"
6"
OVERALL
HEIGHT
2
LIFT
1
3
W
ALL
METHOD 1 (SCREENS 80" AND SMALLER IN
VIEWING WIDTH)
1. Secure the wall bracket to wall studs at the desired
height. Make sure the bracket is level. The top of the
frame will be 1/8" above the top of the wall bracket
when mounted. You will need at least 5/8" clearance
above the bracket to hang the screen. Figures 2, 3, and
4 show the proper orientation for the supplied wall
brackets.
SMALL WALL
BRACKET
Содержание CINEMA CONTOUR SCREEN
Страница 6: ...5 Printed in U S A 87070 Rev 1 08...