- 26 -
D3Engineering.com
▪
585.429.1550
DesignCore™ TDA3x
Product Family
▪
Quick Start Guide
Document No. 00C-131
▪
Version 1.0
▪ Release Date:
1/17/2019
CONFIDENTIAL
▪
26
3.
Enable the Serial Console by following the instructions in
Power on the TDA3x module by plugging in the power cable. Look for output on the Serial
Console as it boots; see
Figure 8
(below):
Figure 8. Serial Console output menu
4.
Setting Capture Settings
Select the image sensor that you plan to use for this run. From the main menu:
a)
Press
S
in your serial console to navigate to
System Settings.
b)
At
System Settings
, press
2
for
Capture Settings.
c)
In the
Capture Settings
menu, input the character shown that corresponds to the image
sensor you're using; for example, to use an IMX390 D3CM, choose
F
; see
Figure 9
(below):
