xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
config 802.1x auth_parameter
response from a RADIUS server.
max_req <value 1-10>
−
Configures the number of times to retry sending
packets to a supplicant (user).
reauth_period <sec 1-65535>
−
Configures the time interval between
successive re-authentications.
enable_reauth [enable | disable]
−
Determines whether or not the Switch will
re-authenticate. Enabled causes re-authentication of users at the time interval
specified in the Re-authentication Period field, above.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To configure 802.1x authentication parameters for ports 1 – 20:
DGS-3400:4#config 802.1x auth_parameter ports 1–20 direction both
Command: config 802.1x auth_parameter ports 1–20 direction both
Success.
DGS-3400:4#
config 802.1x init
Purpose
Used to initialize the 802.1x function on a range of ports.
Syntax
config 802.1x init {port_based ports [<portlist> | all] |
mac_based [ports] [<portlist> | all] {mac_address <macaddr>}]
Description The
config 802.1x init
command is used to immediately initialize the
802.1x functions on a specified range of ports or for specified MAC
addresses operating from a specified range of ports.
Parameters
port_based
– This instructs the Switch to initialize 802.1x functions
based only on the port number. Ports approved for initialization can
then be specified.
mac_based
−
This instructs the Switch to initialize 802.1x functions
based only on the MAC address. MAC addresses approved for
initialization can then be specified.
ports <portlist>
−
Specifies a port or range of ports to be configured.
all
−
Specifies all of the ports on the Switch.
mac_address <macaddr>
- Enter the MAC address to be initialized.
Restrictions Only
administrator-level users can issue this command.
Example usage:
To initialize the authentication state machine of all ports:
DGS-3400:4# config 802.1x init port_based ports all
Command: config 802.1x init port_based ports all
Success.
DGS-3400:4#
142
