D-Link xStack DES-3500 Series, Руководство пользователя

Страница: 229 / 322

DES-3500 Layer 2 Fast Ethernet Switch CLI Reference Manual
225
32
R
OUTING
T
ABLE
C
OMMANDS
The routing table commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
create iproute [default] <ipaddr> {<metric 1-65535>}
delete iproute [default]
show iproute
Each command is listed, in detail, in the following sections.
create iproute default
Purpose Used to create IP route entries to the Switch’s IP routing table.
Syntax
create iproute [default] <ipaddr> {<metric 1-65535>}
Description This command is used to create a default static IP route entry to the
Switch’s IP routing table.
Parameters
<ipaddr>
−
The gateway IP address for the next hop router.
<metric 1-65535>
−
Allows the entry of a routing protocol metric entry
representing the number of routers between the Switch and the IP
address above. The default setting is 1.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To add the default static address 10.48.74.121, with a metric setting of 1, to the routing table:
DES-3526:admin#create iproute default 10.48.74.121 1
Command: create iproute default 10.48.74.121 1
Success.
DES-3526:admin#
delete iproute default
Purpose Used to delete a default IP route entry from the Switch’s IP routing table.
Syntax delete iproute [default]
Description This command will delete an existing default entry from the Switch’s IP
routing table.
Parameters None.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To delete the default IP route 10.53.13.254: