D-Link xStack DES-3228PA, Руководство по установке в сети

Страница: 29 / 274

Initial Configuration
Page 28
Note
The device switch is delivered with no community strings configured.
The following screen displays the default device configuration:
The community-string, community-access, and IP address can be configured through the local terminal during the
initial configuration procedure.
The SNMP configuration options for the Community String are as follows:
•
Access rights options: ro (read only), rw (read-and-write) or su (super).
•
An option to configure IP address or not: If an IP address is not configured, it means that all community mem-
bers having the same community name are granted the same access rights.
Common practice is to use two community strings for the switch one (public community) with read-only access
and the other (private community) with read-write access. The public string allows authorized management sta-
tions to retrieve MIB objects, while the private string allows authorized management stations to retrieve and mod-
ify MIB objects.
During initial configuration, it is recommended to configure the device according to the network administrator
requirements, in accordance with using an SNMP-based management station.
To configure SNMP station IP address and community string(s) perform the following:
1. At the console prompt, enter the command
enable
. The prompt is displayed as #.
2. Enter the command
configure
and press
<Enter>
.
3. In the configuration mode, enter the SNMP configuration command with the parameters including community
name (private), community access right (read and write) and IP address, as shown in the following example:
Console(config)#
show snmp
Community-String Community-Access IP address
---------------- ---------------- ----------
System Contact:
System Location: