D-Link Securicam Network DCS-2000, Руководство пользователя

Страница: 35 / 103

35
Configuration > Tools > Applications (Continued)
Weekly schedule:
Sunday through Saturday - Select the weekdays that should perform the
following operations:
Snapshots begin at - Set the time to start operations. Setting the begin
time the as same as stop time will force operations
to operate continuously
Snapshots stop at - Set the time to stop operations.
Event operation
Delay second(s) before
detecting next event -
Set the time delay before restarting to check the
trigger condition when the current condition is
triggered.
Take snapshots at second(s)
after event -
After a snapshot is taken because of a trigger,
another snapshot will be taken after the configured
seconds.
Trigger condition - There are 4 conditions related to the digital input and
three windows for motion detection. There can be
multiple selections. Select the appropriate digital
input condition according to the characteristics of
the external device. “High”, “low” indicate external
voltage input for level trigger, while “rising”, “falling” is
for edge trigger. There are three windows shown for
the name you defined for motion detection.
“Undefined” will show instead of the window title if
motion detection is not setup yet. In such a case,
clicking on the “Motion detection” in the
note will
direct you to the Configuration page for Motion
detection .
Trigger action - There are four options for two actions regarding to
either condition. They can have multiple selections.
While choosing the trigger output alarm, the digital
output will short both pins to connect the circuit of
the attached external device; otherwise both pins will
be open. While choosing to upload snapshots, the
method can be either email or FTP. The snapshot
names will be “videopre.jpg”, videotrg.jpg”, and
“videopos.jpg” respectively for the snapshots before
event, right upon event, and after event. The date and
time suffix may be added according to the option.
Confirm the external mail or FTP server settings in
network configuration.
Reset output - check and save this option to reset the external
device at the digital output back to the original state.