D-Link Nuclias Connect DAP-2622, Быстрое руководство по установке, Страница: 4 / 8

2
DAP-2622 Quick Installation Guide
ENGLISH
Interface Connectors
1 2 3
PoE
PoE
Figure 2: Bottom Connectors
# Connector Description
1
PoE OUT
+ DATA
Gigabit RJ-45 port for data and
Power over Ethernet (PoE) power.
Supports a maximum of 12 W.
2 DATA
Gigabit RJ-45 port for data.
3 RESET
Press and hold for 20 seconds to
factory reset the device.
Table 2: Interface Description
PoE
PoE
1
Figure 3: Rear Connectors
# Connector Description
1 LAN (PoE)
Port
Gigabit RJ-45 port for data and
Power over Ethernet (PoE).
Table 3: Interface Description
Installation
Using Power over Ethernet (PoE)
1. Use a standard Ethernet cable to connect
the LAN (PoE) port on the back of the
DAP-2622 to a PoE power source device
such as an 802.3at PoE switch.
Configuration
Using Nuclias Connect
The DAP-2622 is designed to be managed
through Nuclias Connect. Refer to the
Nuclias
Connect Manual
for detailed configuration
instructions.
Manual Configuration
Note:
D-Link recommends manually configuring
the device before mounting it. The management
computer, DHCP server and DAP-2622 must be
in the same subnet.
Use one of the following methods to access the
web user interface:
Connecting through Ethernet
1. Use an Ethernet cable to connect the
DAP-2622 to the management computer,
or to the switch or router the management
computer is connected to.
2. Manage the access point from a computer.
Enter
dap2622.local
in the address field
of your browser.
3. Log in to the administration user
interface. The default login information is
Username:
admin
Password:
admin