1 Product Introduction
D-Link Smart Managed Switch User Manual
3
3
Rear Panel
Figure 1.2 – DGS-1100-05 Rear Panel
Power:
Input for a 5V/1A AC adapter.
Reset:
Press the Reset button for 1 to 5 seconds to reboot the Switch. Press the Reset button for 6 to10
seconds to reset the Switch back to the default settings. The LED will light up solid amber for 2 seconds.
When pressing the Reset button for longer than 10 seconds, the device will enter loader mode and the LED
will light up solid green for 2 seconds. If the device cannot reboot, it will automatically enter loader mode.
Alternatively, you can press Reset to power up the device and enter loader mode.
Kensington Lock:
This is used to attach a physical Kensington security lock.
GND:
This is used to connect the Switch to ground.
DGS-1100-05PD
2-Port 10/100/1000Mbps PoE and 3-Port 10/100/1000Mbps with 1 PD port Smart Managed Switch.
Front Panel
Figure 1.3 – DGS-1100-05PD Front Panel
Power LED:
The Power LED lights up when the Switch is connected to a power source. If the Power LED is
Blinking, PoE Pass Through is Off.
Link/Act/Speed LED (Ports 1-5):
Flashing:
Indicates a network link through the corresponding port.
Blinking:
Indicates that the Switch is either sending or receiving data to the port.
Green:
Indicates that the port is running at 1000M.
Amber:
Indicates that the port is running at 10/100M.
Light off:
No link.
PoE PSE LED (Port 1-2):
Solid Green:
PD device insert and power feeding.
Solid Amber:
PD device insert but failure occurs.
Light off:
No PD device insert.
PoE PD (Port 5):
Solid Green:
Receiving power from PSE per 802.3at.
Solid Amber:
Receiving power from PSE per PSE.
Light off:
No link.
Reset:
Press the Reset button for 1 to 5 seconds to reboot the Switch. Press the Reset button for 6 to10
seconds to reset the Switch back to the default settings. The LED will light up solid amber for 2 seconds.
When pressing the Reset button for longer than 10 seconds, the device will enter loader mode and the LED
will light up solid green for 2 seconds. If the device cannot reboot, it will automatically enter loader mode.
Alternatively, you can press Reset to power up the device and enter loader mode.
