D-Link DXS-3600-32S, Быстрое руководство по установке

Страница: 13 / 29

To connect a terminal to the console port:
1. Connect the male DB-9 connector on the console cable to the RS-232 serial port on the computer.
2. Insert the RJ-45 connector into the console port on the front of the Switch. Set the terminal emulation
software as follows:
• Serial port: COM port 1 or COM port 2
• Baud rate: 115200 baud
• Data bits: 8
• Parity: none
• Stop bits: 1
• Flow control: none
• Under Properties, select VT100 for Emulation mode.
• Select Terminal keys for Function, Arrow and Ctrl keys. Make sure to use Terminal keys (not Windows keys)
are selected.
3. After you have correctly set up the terminal, plug the power cord into the power receptacle on the back of
the Switch. The boot sequence appears in the terminal. After the boot sequence completes, the console login
screen displays.
First Time Connecting to the Switch
Upon initial connection to the Switch, the login screen appears (see example below).
By default, there is no Username and Password configured in the account settings of this switch. This will
allow the user to simply connect to this Switch for the first time by pressing the ‘
Enter ’ key. After pressing
Enter, access will be given to enter commands after the command prompt ( Switch> ) appears.
NOTE: the first user automatically gets Administrator level privileges. At least one Admin-level user account
must be created for the Switch.
Logging onto the Web Manager
To access the Web User Interface the user simply runs the standard web browser and enter the Switch’s IP
address into the address bar of the browser and press the ‘
Enter ’ key. By default, the Management port,
located just above the Console port, can be accessed using the IP address of 192.168.0.1/24.
To access any of the other normal LAN ports, other than the Management port, the user needs to configure
an IP address for this interface first before it can be accessed via the Web User Interface:
The PC must have an IP address in the same subnet as the switch. For example, if the switch has an
IP address of 10.90.90.90, the PC should have an IP-address of 10.x.y.z (where x/y is a number between 0 ~
254 and z is a number between 1 ~ 254), and a subnet mask of 255.0.0.0. Open the web browser and enter
10.90.90.90 (the factory-default IP address) in the address bar. Then press <Enter>.
13