D-Link DXS-3600-16S, Руководство по установке оборудования

Страница: 15 / 36

DXS-3600 Series 10GbE Layer 2/3 Switch Hardware Installation Guide
9
Make sure that there is adequate space around the Switch to allow for proper air flow, ventilation, and cooling.
Installing Transceivers into the Transceiver Ports
The switch is equipped with small form-factor pluggable plus (SFP+) ports that can be used to connect various other
networking devices to this switch that do not support the standard copper wiring connection. These ports are generally
used to connect this switch to networking devices that can only be accessed via an optical fiber connection and is
normally used for a connection that spans greater distances. The maximum distance that the copper wiring connection
can reach is 100 meters. Fiber optic connections can span over several kilometers.
The figure below illustrates how to properly insert SFP+ transceivers into the switch’s SFP+ ports.
Figure 2-4 Inserting SFP transceivers into the Switch’s SFP ports
The SFP+ ports also support other transceiver form factors like SFP , SFP+ , and WDM transceivers. A complete list of
SFP/SFP+/WDM transceivers, compatible with this switch, can be found in the “ Port Specifications ” section in
Appendix A, at the end of this document.
Installing Power Modules into the Power Module
Ports
The power module slots, located on the rear panel of this switch, support two types of power supply modules.
AC Power Supply Module:
• DXS-3600-PWR-FB : A 300W AC power supply tray with front-to-back air-flow.
• DXS-3600-PWR-BF : A 300W AC power supply tray with back-to-front air-flow.
DC Power Supply Module:
• DXS-3600-PWRDC-FB : A 300W DC power supply tray with front-to-back air-flow.