D-Link DWC-1000, Справочное руководство

Страница: 101 / 146

Wireless Controller CLI Reference Guide
99
Simple then ospf packets are authenticated using simple
text key.If Authentication Type is MD5 then the interface
authenticates ospf packets w ith MD5 authentication.
12 auth_key Text Key for Simple Authentication type
String
13 md5_key_id Give MD5 Key id
Unsigned integer
14 md5_auth_key Give MD5 text key
String
12.33 net routing ospfv3 configure
<ltinterface>
S.No Com mand Nam e Description Type and Description
1 <ltinterface> ospfv3 configuration mode.
2 save Save OSPFv3 configuration changes.
3 exit Save OSPFv3 configuration changes and exit current mode.
4 cancel Roll back configuration changes.
5 enable Enable/Disable OSPFv3 for a particular interface.
Boolean choice
6 priority
Helps to determine the OSPFv3 designated router for a
netw ork.The router w ith the highest priority w ill be more
eligible to become Designated Router. Setting the value to 0,
makes the router ineligible to beco me Designated Router.
The default value is 1.
Unsigned integer
7 hello_interval
The number of seconds for HelloInterval timer value.Setting
this value, Hello packet w ill be sent every timer value
seconds on the specified interface. This value must be the
same for all routers attached to a common netw ork. The
default value is 10 seconds.
Unsigned integer
8 dead_interval
The number of seconds that a deviceb s hello packets
must not have been seen before its neighbors declare the
OSPF router dow n.This value must be the same for all
routers attached to a common netw ork.The defaul t value is
40 seconds.
Unsigned integer
9 cost The cost of sending a packet on an OSPFv3 interface
Unsigned integer
12.34 net port management configure
<ltportName>
S.No Com mand Nam e Description Type and Description
1 <ltportName> port management configuration mode.
Port name
2 save Save port management configuration changes.
3 exit
Save port management configuration changes and exit
current mode.
4 cancel Roll back port management configuration changes.
5 enable Enable/Disable the port status
Boolean choice
6
auto_negotiation_ena
ble Select this to let the gatew ay and netw ork to determine the
optimal port settings.
Boolean choice
7 duplex_mode
Choose betw een Half Duplex and Full Duplex based on the
port support. The default is Full Duplex for all ports.
select the duplex mode
8 speed
One of three port speeds can be selected: 10 Mbps, 100
Mbps and 1000 Mbps (i.e. 1 Gbps). The default setting is
1000 Mbps for all ports
select the speed