DVG-5102S
User’s Manual
MAINTENANCE
D-Link Systems, Inc.
13
VLAN is optional. It works with the Router or Switch that supports VLAN tag. By adding VLAN tag in
packets may improve efficiency of voice traffic performance and security.
Enable VLAN Tagging:
It is to tag the packets for VLAN Router or Switch identifying.
VLAN ID:
It is to assign uniquely a user-defined ID to each packet.
Priority:
It is the proprietary to VLAN Router or Switch.
Note: Please do not change anything here unless requested by your ISP.
2-1-2 LAN Settings
SETUP
→
LAN Setup
LAN Port Address:
Enter the LAN IP address of the VoIP TA. It is also the default gateway for DHCP
clients.
Subnet Make:
Enter the subnet mask for DHCP clients.
SETUP
→
LAN Setup
Enable Port:
It is to active/des-active LAN port physical connection.
Incoming Rate Limit:
Set the incoming (from LAN to WAN) rate limit of a specific LAN port (can not
exceed the real downstream bandwidth).
Outgoing Rate Limit:
Set the outgoing (from WAN to LAN) rate limit of a specific LAN port (can not
exceed the real upstream bandwidth).
NAT/Bridge:
Select the VoIP Router serving as a
Bridge
between WAN port and LAN port without
NAT.
Note:
If you set a LAN port to be bridge mode that the LAN port will be bundled with WAN. If you
would like to connect to DVG-5102S at the bridged LAN port you must enter WAN port IP.
VLAN ID:
Assign a VLAN ID for DVG-5102S to transit traffic through-out at WAN port for WAN-LAN
