D-Link DSL-G604T, Руководство пользователя

Страница: 23 / 123

DSL-G604T Wireless ADSL Router Manual
3.
Building Materials make a difference: Buildings constructed using metal framing or doors
can reduce effective range of the device. If possible, position wireless devices so that their
signal can pass through drywall or open doorways, avoid positioning them so that their signal
must pass through metallic materials. Poured concrete walls are reinforced with steel while
cinderblock walls generally have little or no structural steel.
4.
Position the antennas for best reception. Play around with the antenna position to see if
signal strength improves. Some adapters or access points allow the user to judge the strength of
the signal.
5.
Keep your product away (at least 1-2 meters) from electrical devices:
Position wireless devices away from electrical devices that generate RF noise such as micro-
wave ovens, monitors, electric motors, etc.
Power On Router
To power on the Router:
1. Insert the AC Power Adapter cord into the power receptacle located on the rear panel of the Router
and plug the adapter into a suitable nearby power source.
2. You should see the Power LED indicator light up and remain lit. The Status LED should light
solid green and begin to blink after a few seconds.
3. If you have the Router connected to your network you can look at the Ethernet Link/Act LED
indicators to make sure they have valid connections. The Router will attempt to establish the
ADSL connection, if the ADSL line is connected and the connection is properly configured this
should light up after several seconds.
Factory Reset Button
The Router may be reset to the original factory default settings by depressing the reset button for a few
seconds while the device is powered on. Use a ballpoint or paperclip to push down the reset button.
Remember that this will wipe out any settings stored in flash memory including IP settings. The
factory default IP address of the Router is 192.168.1.1 and the subnet mask is 255.255.255.0.
23