D-Link DPH-80, Руководство пользователя

Страница: 59 / 101

59
Using Session Initiated Protocol (SIP)
SIP Production Test
LED Test
This is the first test that is performed. This tests the LEDs. In this test, the three
LEDs – Mute
(Red) , Hold (Red) and Speaker (Green ) – glow simultaneously for
a few seconds and then turn off. No tone is played for this test, as the SIP
phone cannot detect if the test is successful.
Key Scan Test
This tests the keys on the IP Phone. In this test, the user needs to press the
keys on the phone in the following order: 0, 1, 2, 3, 4, 5, 6, 7, 8, 9, *, #, ‘mute’,
‘hold’, ‘redial’, and ‘speaker’.
Hook Switch Test
This tests the hook switch. In this test, the default status is on-hook. Start the
test with ‘off-hook’ followed by ‘on-hook’.
Codec Transmit Test
This test determines if the codec transmission is working properly. In this test,
a tone is generated in the handset and speaker simultaneously. It is played and
is not interrupted until the user ends the test by pressing ‘1’ to continue on to
the next test or by pressing ‘0’ to repeat the same test.
Codec Loop Back Test
This test determines if the codec loop back is working properly. In this test, the
user must speak into the microphone and wait to hear their voice repeated
after a delay in the speaker. This test continues until the user ends the test by
pressing ‘1’ to continue on to the next test or by pressing ‘0’ to repeat the same
test.
SRAM Test
For the SRAM testing, a predefined pattern is written into the data SRAM and
program SRAM and is verified after reading from those locations
.