DMS-3130 Series Layer 3 Stackable Managed Switch Hardware Installation Guide
23
The figure below illustrates how to properly insert SFP28 transceivers into the Switch’s SFP28 ports.
Figure 3-4 Inserting transceivers into the transceiver ports
The SFP28 ports support transceiver form factors:
SFP28
and
SFP+
. A complete list of SFP transceivers compatible
with this switch, can be found in
Appendix A - Technical Specifications
document.
Power On (AC Power)
Plug one end of the AC power cord into the power socket of the Switch and the other end into the local power source
outlet. After the system is powered on, the power LED will light up green to indicate that the system has been powered
up.
Power Failure (AC Power)
In the event of a power failure, just as a precaution, unplug the power cord from the Switch. After the power returns,
plug the power cord back into the power socket of the Switch.
Installing Power Cord Retainer
To prevent accidental removal of the AC power cord, it is recommended to install the power cord retainer together with
the power cord. Note that this section only applies to DMS-3130-30TS.
1. With the rough side facing down, insert the tie wrap into the hole below the power socket.
