D-Link DGS-1500-28P, Справочное руководство

Страница: 63 / 113

5 Configuration
D-Link Web Smart Switch User Manual
58
State: Use the drop-down menu to select All, Address, Static or Dynamic. When the user selects address
from the drop-down menu, the user will be able to enter an IP address in the space provided next to the state
option.
Click Add to add a new entry based on the information entered.
Click Find to locate a specific entry based on the information entered.
Click Clear to clear all the information entered in the fields.
L3 Functions > Static Route
The Static Route page provides user to configure the IPv4 Static Route settings.
Figure 5.69 – L3 Functions > Static Route
IP Address: Specifies the IPv4 address of the Static Route.
Netmask: Specifies the Netmask of the IPv4 address entered into the Static Route table.
Gateway: Specifies the corresponding Gateway of the IP address entered into the Static Route table.
Metric (1-65535): Represents the metric value of the IP interface entered into the table. This field may read
a number between 1-65535 for an OSPF setting, and 1-16 for a RIP setting.
Backup State: The user may choose between Primary and Backup. If the Primary Static Route fails,
the Backup Route will support the entry. Please take note that the Primary and Backup entries cannot have
the same Gateway.
Click Add for the settings to take effect.
L3 Functions > Routing Table Finder
The Routing Table Finder page shows the current IPv4 routing table of the Switch. To find a specific IPv4
route, enter an IPv4 address into the Network Address field and click Search.
Figure 5.70 – L3 Functions > Routing Table Finder
L3 Functions > IPv6 Static Route
The IPv6 Static Route page allows user to configure the IPv6 settings.
Figure 5.71 – L3 Functions > IPv6 Static Route