D-Link DGS-1500-28P, Справочное руководство

Страница: 44 / 113

5 Configuration
D-Link Web Smart Switch User Manual
3 3 9 9
Figure 5.38 – L2 Functions > Port Mirroring Settings
Port Mirroring: Enables or disables the Port Mirroring status.
Target Port: Defines the target port.
Source Port Selection:
TX: Duplicates the data transmitted from the source port and forwards it to the Target Port. Click “all” to
include all ports into port mirroring.
RX: Duplicates the data that received from the source port and forwards it to the Target Port. Click “all” to
include all ports into port mirroring.
TX/RX: Duplicate both the data transmitted from and data sent to the source port, and forwards all the data
to the assigned Target Port. Click “all” to include all ports into port mirroring.
None: Turns off the mirroring of the port. Click “all” to remove all ports from mirroring.
Click Apply to capture the configured Source Ports.
L2 Functions > Loopback Detection
The Loopback Detection function is used to detect the loop created by a specific port while Spanning Tree
Protocol (STP) is not enabled in the network, especially when the down links are hubs or unmanaged
switches. The Switch will automatically shutdown the port and sends a log to the administrator. The
Loopback Detection port will be unlocked when the Loopback Detection Recover Time times out. The
Loopback Detection function can be implemented on a range of ports at a time. You may enable or disable
this function using the pull-down menu.
Figure 5.39 – L2 Functions > Loopback Detection Settings