DGS-1210/ME series Metro Ethernet Switch Hardware Installation Guide
2
2
1
1
Assigning IP Addresses
Each Switch must be assigned its own IP Address, which is used for communication with an SNMP network
manager or other TCP/IP application (for example BOOTP, TFTP). The Switch's default IP address is
10.90.90.90. You can change the default Switch IP address to meet the specification of your networking
address scheme.
The Switch is also assigned a unique MAC address by the factory. This MAC address cannot be changed,
and can be found by entering the command
show switch
into the command line interface, as shown below.
DGS-1210-28MP/ME:5# show switch
Command: show switch
Device Type : DGS-1210-28MP/ME
MAC Address : 00-01-02-03-04-05
IP Address : 10.90.90.90 (Manual)
VLAN Name : default
Subnet Mask : 255.0.0.0
Default Gateway : 0.0.0.0
System Boot Version : 1.01.033
System Firmware Version : 7.01.B030
System Hardware Version : B1
System Serial Number : QBDGS12102800
System Name :
System Location :
System up time : 0 days, 0 hrs, 1 min, 2 secs
System Contact :
System Time : 12/08/2016 15:26:11
RTC Time : 12/08/2016 15:26:11
STP : Disabled
GVRP : Disabled
IGMP Snooping : Disabled
VLAN Trunk : Disabled
802.1X Status : Disabled
DGS-1210-28MP/ME:5#
Figure 3.6 Show switch command
The Switch's MAC address can also be found from the Web management program on the
System
Information window
in the Configuration folder.
The IP address for the Switch must be set before it can be managed with the Web-based manager. The
Switch IP address can be automatically set using BOOTP or DHCP protocols, in which case the actual
address assigned to the Switch must be known.
Содержание DGS-1210/ME series
Страница 53: ......
