D-Link DGS-1024D - Switch, Быстрое руководство по установке

Страница: 4 / 16

22
E
N
G
LI
S
H
Installing a Power Cord
Retainer
Installation of a power cord retainer is recommended
to prevent accidental removal of the AC power cord.
A. Insert a tie wrap with the rough side facing down
into the hole below the power socket.
Insert tie wrap
B. Connect the AC power cord into the AC power
inlet of the switch.
Connect the power cord to the switch
C. Attach the retainer to the tie wrap and slide it up to
the end of the cord.
Attach the retainer to the tie wrap
D. Wrap the retainer around the power cord and
place the free end into the fastener.
Wrap the retainer around the power cord
E. Fasten the retainer by pulling on it until secure.
Secure the power cord
F. Connect the AC power cord to an electrical outlet.
Connecting the DGS-1016D/
DGS-1024D to your network
A. Power
The switch can be used with AC power sources 100
- 240 VAC, 50 - 60 Hz. The switch’s power supply
will adjust to the local power source automatically
and may be turned on without having any or all LAN
segment cables connected.
B. Ethernet
These ports support network speeds of 10 Mbps,
100 Mbps, or 1000 Mbps, and can operate in
half-duplex and full-duplex transfer modes. These
ports also support automatic MDI/MDIX crossover
detection, which gives the switch true “plug and
play” capabilities. Just connect any network cable
between the switch and the device, and the switch
will automatically detect the settings of the device and
adjust itself accordingly.