3.40. OSPFProcess
Description
An OSPF Router Process defines a group of routers exchanging routing information via the Open
Shortest Path First routing protocol.
Properties
Name
Specifies a symbolic name for the OSPF process. (Identifier)
RouterID
Specifies the IP address that is used to identify the router. If no router
ID is configured, it will be computed automatically based on the
highest IP address of any interface participating in the OSPF process.
(Optional)
PrivRouterID
The private router ID of this high availability node. (Optional)
RFC1583
Enable this if the security gateway will be used in a environment that
consists of routers that only support RFC 1583. (Default: No)
SPFHoldTime
Specifies the minimum time, in seconds, between two SPF calcula-
tions. (Default: 10)
SPFDelayTime
Specifies the delay time, in seconds, between when OSPF receives a
topology change and when it starts a SPF calculation. (Default: 5)
LSAGroupPacing
This specifies the time in seconds at which interval the OSPF LSAs
are collected into a group and refreshed. (Default: 10)
RoutesHoldtime
This specifies the time in seconds that the routing table will be kept
unchanged after a reconfiguration of OSPF entries or a HA failover.
(Default: 45)
RefBandwidthValue
Set the reference bandwidth that is used when calculating the default
interface cost for routes. (Default: 1)
RefBandwidthUnit
Sets the reference bandwidth unit. (Default: Gbps)
MemoryMaxUsage
Maximum amount in kilobytes of RAM that the OSPF process is al-
lowed to use. The default is one percent of installed RAM. Specifying
0 indicates that the OSPF process is allowed to use all available RAM.
(Optional)
DebugPacket
Enables or disabled logging of general packet parsing events and also
specifies the details of the log. (Default: Off)
DebugHello
Enables or disabled logging of hello packets and also specifies the de-
tails of the log. (Default: Off)
DebugDDesc
Enables or disabled logging of database description packets and also
specifies the details of the log. (Default: Off)
DebugExchange
Enables or disabled logging of exchange packets and also specifies the
details of the log. (Default: Off)
DebugLSA
Enables or disabled logging of LSA events and also specifies the de-
tails of the log. (Default: Off)
DebugSPF
Enables or disabled logging of SPF calculation events and also spe-
3.40. OSPFProcess
Chapter 3. Configuration Reference
159
Содержание DFL-210 - NetDefend - Security Appliance
Страница 19: ...1 6 User roles Chapter 1 Introduction 19...
Страница 83: ...2 4 5 script Chapter 2 Command Reference 83...
Страница 166: ...Default 7 Comments Text describing the current object Optional 3 41 Pipe Chapter 3 Configuration Reference 166...
Страница 210: ...3 59 UserAuthRule Chapter 3 Configuration Reference 210...