D-Link DFE-680TX, Руководство пользователя

Страница: 5 / 48

3
best baud rate, compression method, and error correction method. When the two modems
have tested the phone-line quality and have switched to the combination of parameters
which will provide the best data communication, then you are given the “ connect”
message which signals the end of the inter- modem negotiation and the beginning of your
intended communication with the remote computer.
Autonegotiation between devices within an Ethernet LAN is similar in concept, but much
briefer. The two devices involved in the autone gotiation will be your DFE-680TX and the
switch or hub through which it is connected into the LAN. (Switches ordinarily provide
for autonegotiation; traditional hubs do not.) The parameters to be negotiated between the
DFE-680TX and its supporting switch or hub include speed (100Mbps = Fast Ethernet, or
10Mbps = traditional Ethernet) and duplex mode (half-duplex or full-duplex).
Startup communication between the two devices occurs when both devices are operating,
the cable connection between them is good, and the connected notebook PC's network
software is loaded. As soon as those conditions are satisfied, the preparatory process of
auto-negotiation between the DFE-680TX and its supporting device begins and proceeds
automatically.
If the supporting switch or hub has autonegotiation functionality, then it and the DFE-
680TX exchange a series of messages in which each device signals its capabilities and
listens for corresponding information about the other. The auto-negotiation process
requires only a few milliseconds, and the two devices select the best communication
parameters supported by both devices.
If the supporting device does not have autonegotiation functionality, then its monotone
(single capability) message will be recognized by the DFE-680TX’s autone gotiation
facility, and the DFE-680TX will simply switch to the one of its own capabilities which
matches that of the supporting device.
Once the auto- negotiation is completed, then the line is ready, and it will provide an
optimal data channel between the DFE-680TX and the supporting device. The line will
remain ready without further auto-negotiation action until the linkage is broken. Auto-
negotiation then reoccurs at any time that the linkage is restored, again making the line
ready for optimal data communications.