D-Link DES-3226SM - 1000Mbps Ethernet Switch, Справочное руководство

Страница: 12 / 233

DES-3226S Layer 2 Fast Ethernet Switch User’s Guide
12 Introduction
the ports you assign to these VLANs and IP interfaces will be
removed from the
System interface.
The IP address may be set using the Command Line Interface (CLI)
over the console serial port as follows:
1. Starting at the command line prompt DES3226S:4# −
enter the commands config ipif System ipaddress
xxx.xxx.xxx.xxx/yyy.yyy.yyy.yyy . Where the x ’s
represent the IP address to be assigned to the IP
interface named
System and the y ’s represent the
corresponding subnet mask.
2. Alternaltively, you can enter DES3226S:4#
−
enter the
commands config ipif System ipaddress
xxx.xxx.xxx.xxx/z . Where the x ’s represent the IP
address to be assigned to the IP interface named
System and the z represents the corresponding number
of subnets in CIDR notation.
The IP interface named System on the switch can be assigned an
IP address and subnet mask which can then be used to connect a
management station to the switch’s TELNET or web-based
management agent.