DES-1218/DES-1226 10/100/1000 Mbps Ethernet Switch User’s Guide
11
Side Panels
The right side panel of the Switch contains two system fans. The left side panel
contains heat vents.
The system
fans are used to dissipate heat. The sides of the system also provide heat
vents to serve the same purpose. Do not block these openings, and leave at least 6
inches of space at the rear and sides of the switch for proper ventilation. Be reminded
that without proper heat dissipation and air circulation, system components might
overheat, which could lead to system failure.
Figure 3-4 Side Panels (the right side panel is pictured on top)
LED Indicators
♦
Power
The Power LED will will light green after the switch is powered on to
indicate the ready state of the device.
♦
Link/Act
Located on the upper left corner of each twisted pair port, this LED
indicates a valid link (steady green) and will blink when data is being transmitted
via that port connection.
♦
10/100 Mbps
On the upper right corner of each twisted pair port, this LED will
light when the connection speed is operating at 100 Mbps. An unlit LED indicates
a connection speed of 10 Mbps.
♦
Link
(Optional 2 Port Gigabit Ethernet Module)
Steady green indicates valid link.
Port speed must be designated 1000F for this to light.
♦
Act
(Optional 2 Port Gigabit Ethernet Module)
Blinking Green indicates activity
on port.
