22
D-Link DCS-6045L User Manual
Section 2 - Installation
Step 1:
Place the mounting bracket where you want to position the camera and
use a pencil to mark the holes.
Please refer to the steps below to assist you with mounting the camera. We suggest that you configure the camera before
mounting.
Step 2:
Depending on the material of the wall or ceiling, use proper tools to drill
two holes or screws where you placed the mounting sticker. If the wall is
made out of concrete, drill the holes first, insert the plastic anchors and
then the screws. The space between the camera and the screwheads should
be 3 mm.
Step 3:
If desired, the camera power cord can be concealed behind the mounting
bracket. Run the cable through the back of the mounting bracket, securing
it with the built-in guides. Be sure to leave enough cable length protruding
from the top to allow connection to the camera.
Mounting The Camera
DCS-6045L
6
E
N
G
LI
S
H
mOUNTING THE CAmErA
Step 1:
place the mounting bracket where you want to position the camera
and use a pencil to mark the holes.
please refer to the steps below to assist you with mounting the camera. We suggest that you
configure the camera before mounting.
Step 2:
Depending on the material of the wall or ceiling, use proper tools to
drill two holes or screws where you placed the mounting sticker. If
the wall is made out of concrete, drill the holes first, insert the plastic
anchors and then the screws. the space between the camera and
the screwheads should be 3 mm.
Step 4:
Fasten the mounting bracket to the wall using the screws provided.
Step 3:
If desired, the camera power cord can be concealed behind the
mounting bracket. run the cable through the back of the mounting
bracket, securing it with the built-in guides. Be sure to leave enough
cable length protruding from the top to allow connection to the
camera.
Step 6:
adjust the angle of the arm on the mounting bracket as required.
tighten the thumbscrew to lock the arm in place.
Step 5:
using the supplied thumbscrew, fasten the camera to the mounting
bracket. Connect the camera power cord to the camera.