Mount the Camera
Please refer to the steps below to assist you with mounting the camera.
We suggest that you configure the camera before mounting.
1. Place the arm mount where you want to position
the camera and use a pencil to mark the holes.
Make sure you allow adequate space for the
necessary cables to be routed. The camera can
be mounted to either side of the camera shoe.
2. Depending on the material of the wall or ceiling,
use a 6mm drill bit to drill two holes where you
marked. If the wall is made out of concrete, after
drilling the holes, insert the plastic anchors, and
then insert the screws.
3. The power and Ethernet cables can be concealed
behind the mounting bracket. When you run the
cables through the channel, secure them with
the built-in guides. Leave enough cable length
protruding from the top to connect the cables to
the camera.
4. Fasten the arm mount to the wall using the
screws provided. Lightly pull on the arm mount
to make sure it is fastened securely.
5. Align the camera base mounting guides with
the camera shoe and thumbscrew on the arm
mount. Tighten the thumbscrew to lock the
camera in place.
Do not overtighten the screws as this may crack the bracket.
7
EN
G
LISH
EN
G
LISH
