D-Link DCS-3420, Быстрая установка

Страница: 6 / 110

6
Hardware Installation
Hardware Installation
Connect the Ethernet Cable
Connect an Ethernet cable to the network
cable connector located on the Internet
Camera’s back panel and attach it to the
network.
Attach the Antennas
Locate the antennas included with your
DCS-340 and attach them to the antenna
connectors located on the back of the
DCS-340.
Attach the External Power Supply
Attach the external power supply to the
DC power input connector located on the
Internet Camera’s back panel (labeled
DC 1V) and connect it to an AC power
outlet.
Note: When you have a proper connection, the LED will turn from red to
green. The light may cycle on and off and your computer may show an
intermittent loss of connectivity, this is normal until you have configured your
Internet Camera.
Note: It is required that an Ethernet cable is used during initial
setup. Once your wireless configuration is set, you may disconnect
the Ethernet cable and begin communicating wirelessly with your
DCS-3420.