25
D-Link COVR-3902 User Manual
Section 2 - Installation
Step 2
If the Covr Extender could not be detected, click
Retry
to manually pair the
Extender to the Router using WPS (see
Step 3
below), or click
Skip Covr Setup
to skip adding the Extender and continue configuring the router settings.
Step 3
If the system failed to detect the Covr Extender in the previous step and you
clicked
Retry
, you can use WPS to manually pair the devices. Press the WPS
button on the left side panel of the Extender within the time limit displayed
on the screen. If done correctly, all four wireless LEDs on the Extender will start
to flash. If successful, the wizard will automatically continue to the next step.
If pairing through WPS also fails to detect the Extender, try resetting the
Extender by holding down the reset button on the back of the device for
roughly 10 seconds using an unfolded paper clip. Once reset, run the Setup
Wizard again.
Setup Wizard (continued)
