D-Link 5000 Series, Справочное руководство CLI

Страница: 1232 / 1263

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
1226
13. D-LINK OS Log Messages
This section lists common log messages that are provided by D-LINK OS, along with information
regarding the cause of each message. There is no specific action that can be taken per message. When
there is a problem being diagnosed, a set of these messages in the event log, along with an
understanding of the system configuration and details of the problem) will assist D-LINK in determining
the root cause of such a problem.
Note: This chapter is not a complete list of all syslog messages.
The Log Messages chapter includes the following sections:
•
“Core”
•
“Utilities”
•
“Management”
•
“Switching”
•
“QoS”
•
“Routing/IPv6 Routing”
•
“Multicast”
•
“Technologies”
•
“O/S Support”
Core
Table 15: BSP Log Messages
Component Message Cause
BSP Event (0xaaaaaaaa) Switch has restarted.
BSP Starting code... BSP initialization complete, starting
D-LINK OS application.
Table 16: NIM Log Messages
Component Message Cause
NIM NIM: L7_ATTACH out of order for
interface unit x slot x port x Interface creation out of order.
NIM NlM: Failed to find interface at unit
x slot x port x for event(x) There is no mapping between the USP and
interface number.
NIM NIM: L7_DETACH out of order for
interface unit x slot x port x Interface creation out of order.
NIM NIM: L7_DELETE out of order for
interface unit x slot x port x interface creation out of order.
NIM NIM: event(x),intf(x),component(x),
in wrong phase An eventwas issued to NIM during the
wrong configuration phase (probably Phase
1, 2, or WMU).
NIM NIM: Failed to notify users of
interface change Event was not propagated to the system.