13
These directions are for initial Programming of a new
Launcher, Programming after battery replacement, and
Programming additional Launchers to the Transmitter.
PROGRAMMING RECEIVER/TRANSMITTER
Programming
1.
Verify that the Bird Launcher is off.
2. Choose a number (1-16) on the Launcher Selector
Knob of the Transmitter (optional: label the Launcher
with the number for easy recognition).
3. Push and hold the red Power Button on the Remote
Receiver of the Bird Launcher. Do not release the
Power Button.
4. After approximately 6 seconds of holding the Power
Button down, the Red LED light will flash 4 times.
5.
While continuing to hold the red Power Button
down
, push either the “BIRD/NICK” button or the
“BEEP/CONT” button on the Transmitter for approxi-
mately one second.
6. To indicate the unit has been programmed, the LED
light on the Remote Receiver will flash 5 times and
the Beeper/Locator horn will beep 5 times.
7. After programming confirmation, release the Power
Button on the Remote Receiver.
NOTE
- Do not release the red Power Button until in-
structed to do so or the entire process will have to be
repeated. Repeat the process from the beginning if the
light does not blink 5 times and beep 5 times at the end
of the programming.
CAUTION:
For safety, program the unit while the Launcher is
unloaded and in the ‘open’ position.
