D-CUT TA-070, Руководство по эксплуатации, Страница: 8 / 14

Fig.1
0
图
8
Fig.
9
Cutting:
Insert a piece of tile
under the guide rails
and keep a flat and
straight side against
the gauge. Use the
clap to hold the tile.
Stand along the
saw/table comfortably
and start the saw and
push the saw towards
the tile.
Fill the water tray
with approx.5 gallons
(23liters) of clean
water to the indicated
water level. Water can
be added or refilled
as needed during the
operation of the saw.
Fill Water Pull
－
Push Operation
Two handles are built
within the slide plate
/ motor mechanism. The
saw can be saw can be
either pushed to cut,
or pulled to cut, based
on the operator’s
comfort level or
preference.
Fig.
8 Fig.1
1
Pul
l
Push
Laser Scriber
Pull down the switch
as shown in Fig.9.
The laser will be
opened.
8