D-CUT MD-630, Руководство по эксплуатации

Страница: 4 / 6

4
Changing the Nylon Bar
Use the provided Allan wrench
to remove the ten screws, then
hold the nylon bar and carefully
move it out of nylon bar holder.
Warning: Do not put your
fingers against the sharp edge
of the blade at any time.
Transportation
Put the handle down towards
the working table, and then
move the pins on both sides of
the cam bar as shown to the
hole on the steel column to
keep the blade in a close
position, and then carry the
cutter as shown.
Changing the Blade
Use the provided Allan
wrench to remove the ten
screws, then hold the blade
by each end and carefully
move the blade out of blade
holder.
Note: the flat side of the blade
should face the working table
when install a new blade.
Warning: Do not put your
fingers against the sharp edge
of the blade at any time