D-CUT MD-630, Руководство по эксплуатации

Страница: 3 / 6

3
CUTTING AND C
Installation
Install the wheel assembly to
the cutter base with provided
bolts and nuts as shown.
Then insert the handle into the
handle base as show and
tighten provided screw.
Warning: Do not put your
fingers against the sharp edge
of the blade at any time.
45° Cut
Adjust the angle attachment
to 45°. Insert material
between the cutting blade
and the base, against the
angle attachment as shown,
then press the handle down
to complete a cut.
Warning: Maintain control
of the handle. Do not allow
handle to slam back after
making a cut.
Straight Cut
Insert material between the
cutting blade and the base,
flush it with the guide bar as
shown and hold the material
then press handle down to
complete a cut.
Warning: Maintain control of
the handle. Do not allow
handle to slam back after
making a cut.