D.A.S. RF-12.64, Руководство пользователя

Страница: 21 / 28

15
AX-2RF12 / AX-2RF15
Array Frame.
Mounting instructions.
1.- Flip the speakers upside down. Remove the
existing speaker screws and rubber feet. Replace
the screws used to attach the rubber feet to keep
air from escaping.
2.- Position the speakers in the desired splay
angle.
3.-Attach the joining plates to the enclosures using
the short plates in front and the longer plates in
the rear (see drawing). The holes closest to each
other position the enclosures side to side, forming
a 20º angle between them. Advancing toward the
exterior alternate holes on each side increment the
angles in 5º steps. It is recommended that the
joining plate be placed as symetrically as pos-
sible. On the rear joining plates are two rows of
holes on each side. The outer holes are for RF
enclosures with a 15” bass and the internal holes
are for units with a 12” bass. Flat washers should
be placed adjacent to the joining plates, followed
by the lock washer and finally the bolt.
4.- Slowly flip the speaker assembly so that the
tops of the speakers are facing up.
5.- Screw the joining plates with rigging points to
on the top-front of the enclosure.
6.- Screw the rear joining plates to the enclosures
using a screw in the center and eyebolts on the
ends. If steep vertical angling is needed, the rear
plate can be attached with 3 screws and the
eyebolts can be used in the rear (with-out washers
in this case) panel of the cabinet.
7.- Suspend the enclosures using the eyebolts and
the joining plate with rigging points.
Package contents
4 joining plates (2 with rigging points), 2 rear
joining plates, 14 M10x30 screws, 14
Grower
(split) M10 lock washers, 14 M10 flat washers, 2
M10 eyebolts, 1 number 8 Allen (hex) wrench, 1
number 6 Allen wrench.
EN
Manual del Usuario
/ r / User’s Manual eference