JF-1A Conductivity Sensor
A440-010
December, 2005
12
ATTENTION!
Pushing the sensor to far into the main product line may
result in damage to sensor and require factory re-calibration or repair.
Ensure entry into main product line is clear and free of obstructions.
6.
Push sensor down into product line.
7.
Adjust sensor height (see section 4.5 for high flow conditions)
8.
Turn “black” locking mechanism clockwise to tighten shaft.
28"
PIP
E
C/L
Figure 6
INSTALLATION DRAWING
(Note for high flow rate applications see section 4.5)
PDF created with pdfFactory trial version
