CZone Control X, Руководство пользователя и инструкция по установке

Страница: 17 / 29

17
EN / CZone® Control X User & Installation Manual
2. Connector B
1. Referring to the load and signal input list, strip and crimp the cables with the
appropriate Deutsch contact and crimp tool.
2. Insert the contacts into the DT06-12SA plug following the plugs position
numbers and secure using the locking wedge.
3. Any unused pins in the connector should be plugged with sealing plugs to
maintain the IPX7 rating. (Deutsch part # 114017-ZZ).
4. Before inserting the connector it’s highly recommended to apply a small
amount of silicone grease along the sealing surfaces/gasket. This will make
assembly/disassembly easier.
5. Insert the connector into the Control X until it clicks into place.
6. Secure and neaten up the cables against the bulkhead to reduce the strain
on the connectors.
3. Connector C
1. Connector C has a number of different inputs and outputs available.
Check the table above to ensure your circuit channel is adequate for the
function required. Referring to the circuit list, strip and crimp the input/output
cables with the appropriate Deutsch contact and crimp tool.
NOTE – Pins 1 and 12 are dedicated shunt input pins only. The shunt must
be connected to the same battery as the module input studs and must be
connected to the battery negative.
2. Insert the contacts into the DT06-12SB plug following the plugs position
numbers and secure using the locking wedge.
3. Any unused pins in the connector should be plugged with sealing plugs to
maintain the IPX7 rating. (Deutsch part # 114017-ZZ).
4. Before inserting the connector it’s highly recommended to apply a small
amount of silicone grease along the sealing surfaces/gasket. This will make
assembly/disassembly easier.
5. Insert the connector into the Control X until it clicks into place.
6. Secure and neaten up the cables against the bulkhead to reduce the strain
on the connectors.
4. Connect NMEA2000 network
1. Connect a NMEA2000 drop cable from the Control X to a NMEA2000 backbone.
2. Ensure the NMEA2000 network is properly terminated and connected to a 12V power source (Do not
power up network yet).