Czar PP-8300, Руководство пользователя

Страница: 59 / 91

Step 4: While gently holding the processor down with your finger, secure the processor in the socket with
a screwdriver by turning the socket actuator to the “Lock” position.
▶
Note
»» The CPU fits only in one correct orientation. Do not force the CPU into the socket to prevent
damaging the CPU.
Install a Cooler
The system must not be operated without a cooler (heat sink and fan) to provide the necessarily cooling.
Install the cooling unit supplied as follows:
1. Install the correct CPU as described above.
2. Align the screw holes of the cooler rear retention bracket with the mounting holes on the
underside of the motherboard, located at the four corners of the CPU location.
Insert into the holes and turn the motherboard over.
3. Place the cooler assembly on top of the CPU with the cooling fins aligned with the memory
slots. This will allow the fan to provide cooling the chipset heatsink. Align the screws with the screw
holes of the rear retention bracket.
4. Tighten each screw halfway to secure the cooler assembly to the motherboard. Then
gradually tighten all four screws. Do not fully tighten the first screw before partially
tightening the other screws as this may apply uneven pressure to the CPU, causing damage.
▶
Note
»» Be careful not to touch the thermal pad on the underside of the heatsink. This pad is made of
thermal compound and is deformable. It is designed to make optimal thermal contact with the CPU.
No additional thermal compound is required.
»» Make sure that good thermal contact is made between the processor and heat sink. Insufficient
contact or incorrect use of heat sink, fan, or thermal compound can cause the processor to overheat,
which may crash the system or cause permanent damage to the CPU.
»» Do not forget to connect the CPU fan connector.
»» For proper installation, please kindly refer to the installation manual of your CPU cooler.
58