Cyrus CD i, Инструкция пользователя

Страница: 16 / 18

Cyrus CD i User Instructions
14
TROUbLEShOOTINg gUIDE
If your CD i is not operating properly, disconnect the power
and check all connections using the notes in this handbook.
If problems persist, the checklist below may help.
If you are in any doubt, consult your dealer.
disc spinning with
no sound
Switch off the power to the audio
system and check that connections
have been correctly made from
the CD i to the amplifier.
If used with an external D/A
converter, check the connection
from the ‘DIGITAL OUT’ socket
of the CD i to the D/A converter.
Check also that power is applied
to the D/A converter and amplifier
and that the input selection and
volume control of these units is
correctly set.
Pause may have been set. Check
for the pause symbol on the
display. Press the PLAY/PAUSE
key again on the front panel or
handset to cancel pause.
Skipping tracks or
distorted sound
The disc may be dirty or badly
scratched. Try playing another
disc. If the other disc plays ok, try
cleaning the 1st disc.
Indication ‘Disc
error’ on the display
The disc will not read. It may be
dirty or defective.
No display The display may have been
switched off at the handset. Press
the display key again to restore
the display and backlight.
No Remote
Operation
The handset may not be set to
control the CD i . Press the cd
button and retry commands.
The handset batteries may need
to be replaced:
Remove the battery compartment
cover located underneath the unit.
Remove the batteries and replace
with new ones carefully noting the
orientation marked in the bottom
of the battery case.
The batteries in the unit should
only be replaced with new
batteries type AAA (I.E.C. LR03).
SPECIfICATIONS
Power Supply
Voltage: ........................................... As plate on rear of unit
Power Consumption ..................................................... 12W
EMC & Safety Compliance (230V) ....................................ce
Enclosure
Dimensions (WxHxD) .............................. 215 x 75 x 365mm
Weight ......................................................................... 3.6kg
Material ....................................................... die cast chassis
Analogue Audio Performance
Output Level ........................................................... 2.1V rms
Frequency Response ......................... 20-20,000Hz ±0.25dB
Channel Separation .................................... >110dB @ 1kHz
>90dB@20kHz
SNR (using silent track) .......................................... >106dbA
THD @ -10dB ............................................................ 0.003%
Disc compatibility ........................................ CD Audio, CD-R
Digital Audio Performance
Coaxial Digital Output ...................................... 500mV pk-pk
Output Impedance ...................................................... 75 Ω
Optical Output ........................... Toslink optical connection
Sample rate accuracy ................................... 44.1k ± 50ppm
Clock Jitter .................................................................. <75ps
Disc compatibility ........................................ CD Audio, CD-R
Cyrus reserves the right to change all specifications without notice. E &OE