Rev02
Cypress Envirosystems
OEM User Manual
Page 6
interference and (2) this device must accept any interference received,
including interference that may cause undesired operation.
RF Exposure info:
This equipment complies with the FCC RF radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with a
minimum distance of 20 centimeters between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
The antennas used for this transmitter must be installed to provide a separation distance
of at least 20cm from all persons and must not be located or operating in conjunction
with any other antenna or transmitter.
Antenna Support:
Up to 7.4dBi Omni tested under FCC part 15.247 rules.
Certified with:
•
NKG SF-245WR (7.4dBi)
•
Centurion NanoBlue-FL04 (2.0dBi)
Co-location of Additional Transmitters
Digital Electronic Devices manufacturers using this MA grant should refer to Appendix B
(FCC Grant #) for end-products using two or more co-located RF transmitters. This grant
states:
“This modular transmitter is approved for use in Digital Electronic Devices
and may operate in conjunction with other mobile and portable transmitters in
the same device; provided, the other mobile and portable transmitters have
satisfied the appropriate RF exposure requirements contained in the FCC
rules. The grantee must also provide Digital Electronic Device integrators, or
end users if marketed directly to end users, with installation and operating
instructions for satisfying RF exposure requirements. The Grantee must
inform second manufacturers/installers that in order for this module to be
operated in any configuration other than that permitted in the preceding
sentences, a separate FCC equipment authorization must be obtained for
each device into which this module is installed.“
This modular approval is granted provided Digital Electronic Devices manufacturers
assume responsibility for ensuring that other transmitters operating in conjunction with
the WiFi3309701 comply with RF exposure requirements associated with their use. The
use of one or more additional RF transmitters will require review by the FCC and may
require end-product recertification, including the WiFi3309701 to ensure emissions
compliance and RF safety. It is the sole responsibility of the Digital Electronic Device
manufacturer to obtain end-product regulatory compliance for configurations including
two or more RF transmitters.
