Cypress PSoC CY8CTMG20 Series, Техническое справочное руководство

Страница: 224 / 308

224 PSoC CY8CTMG20x and CY8CTST200 TRM, Document No. 001-53603 Rev. *C
PT1_CFG
0,B3h
21.3.36 PT1_CFG
Programmable Timer 1 Configuration Register
This register configures the programmable timer 1.
In the table above, note that reserved bits are grayed table cells and are not described in the bit description section below.
Reserved bits must always be written with a value of ‘0’. For additional information, refer to the
Register Definitions on
page 163 in the Programmable Timer chapter .
2 CLKSEL This bit determines if the timer runs on the 32 kHz clock or CPU clock. If the bit is set to 1'b1, the timer
runs on the CPU clock, otherwise, the timer runs on the 32 kHz clock.
1 One Shot 0 Continuos count mode. Timer reloads the count value from the data registers upon each
terminal count, and continues counting.
1 One-shot mode. Timer goes through one complete count period and then stops. Upon com-
pletion, the START bit in this register is cleared.
0 START 0 Timer held in reset.
1 Timer counts down from a full count determined from its data registers (PT_DATA1,
PT_DATA0). When complete, it either stops or reloads and continues, based on the One
Shot bit in this register.
Individual Register Names and Addresses:
0,B3h
PT1_CFG : 0,B3h
7 6 5 4 3 2 1 0
Access : POR RW : 0 RW : 0 RW : 0
Bit Name CLKSEL One Shot START
Bit Name Description
[+] Feedback