SOFTUNE Workbench Getting Started
FR Family FR81S Series, Emulation System, Doc. No. 002-04887 Rev. *A
29
Figure 5-16. Command Window with System Information
To enter into high speed mode several steps must be executed:
Open the command windows as follows: [View] > [Command]. Enter “show system” into text field and some
system information is prompted. In the line with text ‘PLL clock’ the left value marked in red shows the real VCO
clock (e.g. ~80MHz in Figure 5-16). The right value corresponds to selected frequency of high speed mode.
After detection of the frequency the debug session must be stopped. Then the high speed mode can be enabled
by clicking [Setup] > [Debug Environment] > [Debug Environment] > Tab [Frequency] > [Enable]
(see Figure 5-17
). Enter the integer value of the PLL clock command window line and press on ‘OK’ button.
