CY8CKIT-050 PSoC® 5LP Development Kit Guide, Doc. # 001-65816 Rev. *E
33
5.
Code Examples
To access code examples described in this section, open the PSoC Creator Start Page. For
additional code examples, visit
http://www.cypress.com
.
Figure 5-1. PSoC Creator Start Page
Follow these steps to open and program code examples:
1. Click on a code example from
Examples and Kits
on the PSoC Creator Start Page.
2. Create a folder in the desired location and click
OK
.
3. The project opens in PSoC Creator and is saved to that folder.
4. Build the code example to generate the hex file.
5. To program, connect the board to a computer using the USB cable connected to port J1, as
described in
On-board Programming Interface on page 21
. The board is detected as DVKProg5
6. Click
Debug >
Program
.
7. The programming window opens up. If the silicon is not yet acquired, select the DVKProg5 and
click on the
Connect
button.
8. The silicon is acquired and is shown in a tree structure below the DVKProg5.
9. Click
OK
to exit the window and start programming.
electronic components distributor
