Cypress CY4603, Руководство пользователя

Страница: 53 / 94

HX3 Kits User Guide, Doc. #: 001-91203 Rev. *D 53
HX3 Blaster Plus Tool
5. The following example illustrates the procedure to change the PID for the USB 3.0 hub interface
and verify the updated PID.
a. Click
Always display settings from EEPROM check box located near the menu bar to read
the current settings stored on the EEPROM.
b. Modify the value of USB 3.0 PID listed in the General Settings group to ‘x7500’.
c. Click the Download Fi Settings… button to write the modified settings to EEPROM
along with custom firmware, as shown in Figure 4-17 .
Figure 4-17. Downloading Custom Firmware and Configuration Settings
Notes :
1. Since the HX3 hardware is configured for custom firmware mode by default, always make sure
to download the firmware along with the configuration settings.
2. In case you want to change the PID value for USB 3.0 or USB 2.0 hubs, make sure not to
assign any of the other standard PID values allocated for HX3 kits as listed in
Table 3-5 on
page 26 .
d. Click Yes to confirm the download operation.
Figure 4-18. Confirming Firmware and Configuration Setting Download