Rear Panel
1.
RS-232:
Connect to a PC or control system with D-Sub 9-pin cable for the
transmission of RS-232 commands.
2.
IP & ETHERNET:
This port is the link for Telnet or WebGUI controls, connect to an active
Ethernet link with an RJ45 terminated cable (for further details, please refer
to sections Telnet Control & Web GUI).
Warning:
Please do not connect more than one active Ethernet link within
the Matrix system.
3.
SERVICE:
Manufacturer use only.
4.
CAT5e/6/7 OUT A~D:
Connect from these CAT outputs to the CAT input port of the Receiver units
with a single CAT5e/6/7 cable for HDMI Audio/Video and IR/RS-232 control
signal transmission.
Warning:
Please do not connect the CAT5e/6/7 cable into the Receiver's
LAN port.
5.
IR IN 1~4:
Connect to the IR extenders for IR signal reception. Ensure that the remote
being used is within the direct line-of-sight of the IR extender for it will send
out the IR signal to the selected Receiver's IR OUT.
6.
IR OUT 1~4:
Connect to the IR Blasters for IR signal transmission.
Place the IR Blaster in direct line-of-sight of the equipment to be controlled
for it will blaster out the IR signal received from the Receiver side chosen by
input selection.
7.
HDMI IN 1~4:
Connect to the HDMI input source devices such as a DVD player or a Set-
top Box with HDMI cable or DVI to HDMI cable.
8.
ALL IR OUT:
Connect to the IR Blaster for IR signal transmission to the source side.
Place the IR Blaster in direct line-of-sight of the equipment to be controlled
for it will blaster out all signal received from the IR IN at the Receiver sides.
9.
ALL IR IN:
Connect to the IR extender for IR signal reception. Ensure that remote being
used is within the direct line-of-sight of the IR extender for it will send out the
signal to all Receiver's IR OUT.
10.
DC 24V:
Plug the 24 V DC power supply into the unit and connect the adaptor to an
AC outlet.
