Cypress Semiconductor CY3215-DK, Руководство пользователя

Страница: 26 / 38

25 CY3215-DK PSoC 1 In-Circuit Emulator Development Kit Guide, Doc. # 001-66514 Rev. *B
Using ICE-Cube Connector
3.3 PSoC Programmer
PSoC Programmer is used as a standalone application to program PSoC devices. It can be
launched within PSoC Designer or accessed from the desktop as a standalone program.
Figure 3-21. PSoC Programmer Interface
To program a target board using PSoC Programmer via ICE-Cube pod connector, follow these steps:
1. Set up all hardware, including the device to be programmed.
2. Disconnect power from the target board.
3. Launch PSoC Programmer:
a. From the desktop, click Windows Start > All Programs > Cypress > PSoC Programmer.
b. From within PSoC Designer, click Program > Program Part.
4. Click File Load to select a file for programming.
5. Select the port used to connect the programmer.
6. Select the device family and device used to generate the hex file.
7. Select Reset under programming mode.
8. Apply power to the target board.
9. Click Program to start device programming.
10.The action window reports the status and success of programming.