CYP PUV-2600RX, Руководство по эксплуатации

Страница: 19 / 44

19
port. Click on one or more input buttons on the left and then select
the new HDCP mode to use from the choices on the right. The buttons
will change colour as you select them and the change in HDCP
behavior will occur immediately across all selected Inputs. “Reference
to Source” will make the input operate using the HDCP version
required by the connected source. “Reference to Display” will limit the
input to only accept the HDCP version supported by the connected
display. Selecting “Disable” will completely disable HDCP support on
that input.
6.5.4 USB Tab
This tab provides a way to select which USB Host Port (USB Type B) is
currently active.
Note: Changing the USB host will force the HDBaseT connection to briefly
disconnect while it reconfigures. The connected host (PC, Laptop, etc.) may
also take a moment to detect all available devices.
1) Set USB Mode: Select the preferred USB Host Port, from the displayed
selection, to use as the currently active connection. The change will
occur immediately and all USB Device Ports (USB Type A) on the
Transmitter and Receiver will connect to the new host.
Note: When "Remote Host" is selected, Host Port 1 on the Transmitter will
become active. To select Host Port 2 on the Transmitter, please use the
Transmitter's WebGUI.