16
■
Wait:
Set the length of time, in seconds, to wait after this
CEC Automation Event has been activated before ANY other
Automation Event can be detected.
■
CEC Command:
Set the CEC command to send when the specified
Automation Event is activated. Clicking the “Test” button will send
the command immediately. Available CEC commands are:
– Power Off:
Turn off the connected HDMI display device.
– Power On:
Turn on the connected HDMI display device.
– Active Source:
Force the connected HDMI display device to
switch to the HDMI input that this unit is connected to.
Note: Not all HDMI devices support all CEC commands.
■
RS-232:
Enable or disable sending an RS-232 command when the
currently selected Automation Event is activated.
Note: The RS-232 port must be in “Control” mode to send commands
to external devices.
■
Delay:
Set the length of time, in seconds, that the specified
Automation Event must continue to be true before sending the
defined RS-232 command.
■
Wait:
Set the length of time, in seconds, to wait after this RS-
232 Automation Event has been activated before ANY other
Automation Event can be detected.
■
RS-232 Command:
Click the Edit icon ( ) to define the RS-
232 command to send when the specified Automation Event
is activated. Clicking the “Test” button will send the command
immediately.
2) RS-232 Setting:
Provides controls to configure the settings and
behavior of the RS-232 port.
■
Mode:
Switch the behavior of the RS-232 port between “Console”
and “Control”. When “Console” is selected, the unit can receive
and be controlled directly via RS-232 commands. When “Control”
is selected the RS-232 port can send Automation commands to
control other devices.
■
RS-232 Setting Edit:
Click on the Edit icon ( ) to configure the
various RS-232 port settings including baud rate, data length,
parity and stop bits.
